Water sorption and cooking time of red kidney beans (Phaseolus vulgaris L.): part I – Effect of freezing and drying conditions on water sorption and cooking time

Water sorption and cooking time of kidney beans were determined. The beans were manually harvested at 19.2 ± 0.1% moisture content and stored at ?20 and ?10 °C for about half a year. The beans were further dried at 30, 40 and 50 °C inside a thin‐layer drier for 7.5 h or under room conditions for 4 week. The freezing storage temperature before the beans were dried did not influence their cooking time and water sorption. The saturated kernel volumes decreased approximately 7% after drying. The beans decreased their sphericity during water sorption and had a larger swelling ratio in the thickness direction than in other directions. Lower initial moisture content, especially with a higher drying temperature, decreased water sorptivity and resulted in higher percentage of uncooked kernels if the beans were not soaked before cooking. However, there was no relationship between initial moisture content and uncooked percentage if the beans were soaked before cooking. High drying temperature resulted in hard‐to‐cook (HTC) phenomenon.     

Changes in soil carbon stock after cropland conversion to grassland in Russian temperate zone: measurements versus model simulation

The collapse of Soviet Union in early 1990s led to abandonment of large area of arable land which is assumed to act as a carbon (C) sink. We studied the ability of two dynamic soil C models (Yasso07 and RothC) to predict changes in soil C content after cropland abandonment. The performance of the models was compared using the results of a long-term experiment in Pushchino, Moscow region (54°50′N, 37°35′E) in Russia. The experiment was divided in four combinations of fertilizer or mowing treatments on former cropland soil. The soil C content was determined in the year of establishment (1980) and thereafter in 1999 and 2004. The soil C stocks increased by about 1.5- to 1.8-fold during the study period. Both models predicted the overall change in soil C relatively well (modelling efficiency of Yasso07 and RothC were 0.60 and 0.73, respectively). According to the models, the soil gained on average 140–150 g C m^?2 year^?1 during the first 5 years after conversion of cropland to grassland. The C sequestration rate decreased to 40–50 g C m^?2 year^?1 after 20 years of land use change. The sequestration rates estimated in this study are comparable to the rates observed in other studies.     

Influence of Surface Morphology on the Torsion Fracture of NiTi Endodontic Instruments

This study analyzed the influences of manufacturing process (twisting and machining) and surface finishing on the angular distortion, maximum torque, and toughness of two NiTi endodontic instruments (Race—FKG Dentaire and TF—Twisted Files, SybronEndo). Statistical analysis of results showed that TF instruments (twisted) had higher distortion angle (p < 0.05) and lower maximum torque to fracture (p < 0.05) than Race instruments (machined). SEM analysis of fractured instruments showed a surface morphology characteristic of ductile fracture, with plastic deformation in the helical shafts. The results suggest that both instruments are equally suitable for clinical applications. This study is purely scientific as it evaluates only some material properties, and is not intended to endorse a commercial product.     

控制醋酸生产的滗析器相分离

正专利披露了控制醋酸生产的滗析器相分离方法,醋酸是甲醇羰基化反应生产的。方法包括测量反应器混合物中醋酸甲酯浓度,根据测量得到的醋酸甲酯浓度,计算滗析器重,有机相的密度,调节反应器或滗析器的操作条件,保证滗     

Brazil’s new national policy on solid waste: challenges and opportunities

Brazil, one of the world’s largest developing countries, has recently introduced a new solid waste management regulatory policy. This new regulatory policy will have implications for a wide variety of stakeholders and sets the stage for opportunities and lessons to be learned. These issues are discussed in this article.     

Oxygen reduction reaction on a Pt/carbon fuel cell catalyst in the presence of trace quantities of ammonium ions: An RRDE study

The effect of trace quantities of ammonia on oxygen reduction reaction (ORR) on carbon-supported platinum catalysts in perchloric acid solutions is assessed using rotating ring disk electrode (RRDE) technique. The study demonstrates that ammonia has detrimental effects on ORR. The most significant effect takes place in the potential region above 0.7 V vs RHE. The effect is explained by the electrochemical oxidation of ammonia, which blocks Pt active sites and increases the formation of H₂O₂. This leads to losses in the disk currents and increments in the ring currents. The apparent losses in ORR currents may occur in two ways, namely, through the blocking of the active sites for ORR as well as by generating a small anodic current, which is believed to have a lower contribution. In addition, a detrimental effect of sodium cations in the potential range below 0.75 V vs RHE was demonstrated. This effect is most likely due to the co-adsorption of sodium cations and perchlorate anions on the Pt surface.     

Parallel discovery of network motifs

Many natural structures can be naturally represented by complex networks. Discovering network motifs, which are overrepresented patterns of inter-connections, is a computationally hard task related to graph isomorphism. Sequential methods are hindered by an exponential execution time growth when we increase the size of motifs and networks. In this article we study the opportunities for parallelism in existing methods and propose new parallel strategies that adapt and extend one of the most efficient serial methods known from the Fanmod tool. We propose both a master–worker strategy and one with distributed control, in which we employ a randomized receiver initiated methodology capable of providing dynamic load balancing during the whole computation process. Our strategies are capable of dealing both with exact and approximate network motif discovery. We implement and apply our algorithms to a set of representative networks and examine their scalability up to 128 processing cores. We obtain almost linear speedups, showcasing the efficiency of our proposed approach and are able to reach motif sizes that were not previously achievable using conventional serial algorithms.     

Sodium phthalamates as corrosion inhibitors for carbon steel in aqueous hydrochloric acid solution

Three compounds of N-alkyl-sodium phthalamates were synthesized and tested as corrosion inhibitors for carbon steel in 0.5 M aqueous hydrochloric acid. Tests showed that inhibitor efficiencies were related to aliphatic chain length and dependent on concentration. N-1-n-tetradecyl-sodium phthalamate displayed moderate efficiency against uniform corrosion, 42–86% at 25 °C and 25–60% at 40 °C. Tests indicated that compounds behave as mixed type inhibitors where molecular adsorption on steel followed Langmuir isotherm, whereas thermodynamic suggested that a physisorption process occurred. XPS analysis confirmed film formation on surface, where Fe⁺² complexes and Fe⁺² chelates with phthalamates prevented steel from further corrosion.